FAQ
Chemistry Flasks for Unreal · FAQ
The liquid does not render correctly in my project.
The liquid raymarcher reads the custom depth written by the liquid volume mask of the blueprint. Check that Custom Depth-Stencil Pass is enabled in the Rendering section of the Project Settings, as it is in the sample project, and that the mask part of the blueprint has not been removed.
All the copies of a flask change at the same time.
Copies of the same blueprint share its material instance. Create a new material instance from M_LiquidVolume for each copy and assign it to the liquid volume of that copy. The 1000 ml Kjeldahl and the 1000 ml Volumetric blueprints also share one instance, MI_LiquidVolume_Volumetric_1000ml.
Can I rotate a flask?
Yes. Flasks can rotate 360 degrees and the liquid follows gravity. The liquid cannot leave the flask, but you can change FillLevel while the flask is upside down to simulate pouring.
Can I put objects inside a flask?
Yes. Opaque objects placed inside a flask intersect the liquid correctly.
How do I stop or speed up the liquid animation?
Turbulence multiplies all the turbulence options. A value of 0 stops the animation of the liquid and the foam. FoamTurbulence sets the speed of the foam animation.
How can I make the liquid cheaper to render?
Lower LiquidRaymarchSteps and FoamRaymarchSteps. Fewer steps run faster but are less accurate, and the foam usually does not need many steps.
Suggest an improvement
Help us improve this documentation page.